Problem solving guide
65
Message Cause and remedy
Clean the fluff filter.
Check the air-
ways.continues
to light up after a
programme has
been cancelled,
despite thorough
cleaning.
The plinth filter looks clean after thorough cleaning.
However, the programme terminates and the error
message appears again. It is likely that there is still
underlying residue that could not be removed.
To switch off the message: confirm OK.
Check for the possible causes described below.
The heat exchanger is clogged.
Check the heat exchanger. Follow the instructions
in “Problem solving guide – Checking the heat ex-
changer”.
The plinth filter is clogged further down.
Check the plinth filter. Follow the instructions de-
scribed in “Problem solving guide – Replacing the
plinth filter”.
If the plinth filter is not out of shape or damaged,
you can reactivate it in a washing machine. Follow
the instructions described in “Problem solving
guide – Reactivating the plinth filter”.
Empty the container
or check the drain
outlet lights up
after a pro-
gramme has
been cancelled.
The condensed water container is full or there is kink
in the drain hose.
Empty the condensed water container.
Check the drain hose.
To switch the fault message off:
Open and close the door while the dryer is
switched on or switch the dryer off and back on
again.
Obstruction detec-
ted. Untangle laun-
dry and restart.
lights up after a
programme has
been cancelled.
The laundry is unevenly distributed or has rolled up.
Open the door and loosen the laundry. Remove a
few items if necessary.
Switch the tumble dryer off and then on again.
Start a programme.
To Next Page
Loading...
Need help?
General
