3. Select a programme and start it
29
Starting a programme
Touch the flashing Start/Stop sensor.
The Start/Stop sensor will light up.
Notes
If a delay start time has been selected,
then this will count down in the time
display. At the end of the delay start
time or immediately after the pro-
gramme has started the programme
duration will appear in the time display.
With a longer delay start time, the drum
will rotate occasionally to untangle the
laundry. This is not a fault.
– The Perfect Dry indicator will only
flash/light up with programmes with
selectable drying levels (see also
“Operating the tumble dryer”).
– The dryer measures the residual
moisture of the laundry and calcu-
lates the required programme dura-
tion.
If a small load or dry laundry is
placed in the dryer, it is dried/aired
for a preset duration. In this case the
Perfect Dry indicator does not light
up at the end of the programme.
To prevent laundry wearing out
avoid overdrying it.
Energy savings
After 10 minutes, the indicators dim and
the Start/Stop sensor starts flashing.
Touch the Start/Stop sensor to switch
the indicators on again (this does not
have any effect on a running pro-
gramme).
– Before the programme finishes, the
laundry is cooled.
To Next Page
Loading...
