Miele W 1901 WPS - One of the following fault messages appears in the display

One of the following fault messages appears in the display
Fault message Possible cause Remedy
1)
2
Fault
Water intake
Open stopcock
The water inlet is
blocked or
restricted.
Check whether
–
the stopcock is
opened properly.
–
the inlet hose is kinked.
–
the water pressure is
too low.
2
Fault
Check drainage
system
–
The water outlet is
blocked or
restricted.
– The drain hose
has been fixed
too high.
–
Clean the drain filter
and the drain pump.
–
The maximum delivery
head is 1 m.
L
Waterproof system
activated
Close the stopcock
The water protection
system has reacted.
– Close the stopcock.
– Call the Service
Department.
;
Technical fault xxx
Call Service
There is a fault. Start the programme
again.
If the fault message
appears again, contact
the Service Department.
1)
To switch off the fault message: Switch the machine off with the K button.
Problem solving guide
46