Fault Possible cause Remedy
The check light p
flashes, the r End
indicator light is on,
but the laundry in
the machine has
not been washed.
The water inlet is
blocked.
– Turn the programme selector to
r End.
– Open the stopcock(s).
– Select a programme.
– Press the h Start button.
If little or no water is taken in during
the next programme, the water
pressure may be too low. If it is
adequate there may be a technical
fault. In this case, call the Miele
Service Dept.
The
q indicator
light is flashing.
The drainage
system is blocked.
Check whether
– the drainage system is blocked,
See “Cleaning the drainage
system” in “Cleaning and Care”.
The programme se-
quence indicator
light
i Pre-Wash is
flashing.
There is a fault. Start the programme again.
If the indicator light flashes again,
call the Miele Service Dept.
The programme se-
quence indicator
light
j Main wash
flashes during or at
the end of a pro-
gramme.
There is a fault. If the indicator light flashes again
when the next programme is run,
call the Miele Service Dept.
The programme se-
quence indicator
light
n Rinse 1 or
n Rinse 2 flashes.
There is a fault. Start the programme again.
If the indicator light flashes again,
call the Miele Service Dept.
Problem solving guide
33
To Next Page
