Problem solving guide
With the help of the following notes minor faults in the performance of the ap-
pliance, some of which may result from incorrect operation, can be put right with-
out contacting the Service Department.
Repair work to electrical machines should only be carried out by a suitably
qualified engineer in accordance with local and national safety regulations. Un-
authorised repairs could be dangerous.
Fault Possible cause Remedy
The I / h On/Start indic-
tor light does not light
up. The programme
does not start.
There is no power
supply to the machine.
Check that
– the door is properly closed.
– the plug is correctly
inserted in the socket and
the mains electricity supply
is switched on.
– the fuse or circuit breaker
has not tripped.
The p check light
flashes, although the
programme has fin-
ished as usual.
The water inlet is
restricted.
– Open the stopcock fully.
– Check the inlet hoses for
kinks.
– The water pressure is too
low
The filters in the inlet
hoses are blocked.
– Clean the filters (see
section “Cleaning the filters
in the water inlet”).
The indicator light goes out
when the programme selector
is turned to the r End
position.
Problem solving guide
32
To Next Page
