Miele WWD 120 - Programmable Functions; Selecting and Accessing Functions

Programmable functions
71
The programmable functions are used
to alter the machine's electronics to
suit changing requirements.
Programmable functions can be
altered at any time.
The programming is carried out in eight
steps (, ,  ... ) using the sensor
controls.
Accessing the programming level
Pre-requisites:
- The washing machine is switched on
(the programme selector is pointing
to a wash programme).
- The washing machine door is open.
 Touch the Start/Add laundry sensor
and leave your finger on it whilst
carrying out steps -.
 Close the washing machine door.
Wait until the Start/Add laundry sensor
lights up constantly ...
 ... and then take your finger off the
Start/Add laundry sensor.
After approx. four seconds,  will light
up in the time display.
Choosing and selecting a
programmable function
The number of the programmable
function will appear in the time display
as and a number: e.g..
 Touch the or sensor control to
scroll to the next or previous
programmable function:
Programmable functions
 Keypad tone
 PIN code
 Control field switch-off behaviour
 Memory
 Additional long pre-wash – Cottons
 Gentle action
 Reduced temperature
 Water plus
 Water plus level
 Maximum rinse level
 Suds cooling
 Anti-crease
 Low water pressure
 Display brightness dimmed
 Confirm the selected programmable
function by touching theStart/Add
laundry sensor control.