Mighty Mac LSC505 - User Manual

LSC503,LSC505, LSC508
Operating & Assembly Instructions For
Mighty Mac Leaf Shredder-Chipper
This manual contains information concerning
proper and improper operating procedures,
warnings, maintenance, trouble shooting, assem-
bly, tips. Everyone who operates this machine
should read these instructions and be thoroughly
familiar with them.
THIS MACHINE" IS CAPABLE OF INFLICTING
SERIOUS INJURY IF OPERATED IMPROPERLY -
READ WARNING & CAUTION LABELS
(215) 495-7181 • MacKISSIC, INC .• P.O. BOX 111, PARKER FORD, PA 19457 • FAX (215) 495-5951
Form LSC692

Summary

Model Information and Introduction

Critical Safety Warning

Machine's potential for serious injury if operated improperly.

Safety Rules and Hazard Identification

Rules for Safe Operation

General directives for safe use of the shredder-chipper.

Specific Dangers and Hazards

Highlights critical risks like rotating blades and crushing.

Operator Responsibilities and Safety Gear

Operators Responsibilities

User's duties for safe machine operation.

Recommended Safety Wear

Specifies essential protective gear for operation.

Operation and Material Handling

Eye Protection During Operation

Mandatory use of safety glasses.

Key Operating Cautions

Specific rules to follow during operation.

Assembly Instructions

Assembly Preparation Steps

Disconnect spark plug before assembly.

Attaching the Feed Hopper

Procedure for installing the feed hopper assembly.

Attaching the Discharge Cover

Procedure for installing the discharge cover.

Pre-Operation Setup and Fill-up

Engine Oil Fill-up Procedure

Steps for adding the correct engine oil.

Oil Viscosity and Capacity Chart

Starting the Engine

Engine Starting Sequence

Step-by-step guide to start the engine.

Discharge Cover Installation Check

Engine Operation and Stopping

Engine Starting Refinements

Engine Stopping Procedure

Operation Safety During Use

Warnings about discharge velocity and PPE.

Material Handling and Hopper Adjustment

Material Size Restrictions

Maintenance and Screen Cleaning

Engine Lubrication Schedule

Guidelines for checking and changing oil.

Screen Removal and Cleaning

Blade Maintenance and Replacement

Chipper Knife Service

Tri-Lobe Blade Service

Troubleshooting Common Issues

Engine Start Failures

Diagnosing and fixing engine starting problems.

Power Loss and Erratic Operation

Engine Overheating Solutions

Excessive Vibration Causes

Discharge Obstruction Fixes

Mighty Mac LSC505 Specifications

General

Security Level	P-2
Shred Type	Strip-Cut
Type	Strip-cut
Sheet Capacity	5 sheets
Shred Size	1/4 inch
Power	120V