Mighty Mule FM134 - User Manual

User Guide
FM135
Single Button
FM134
Two Button
Programming the FM134 and FM135 Remote to Mighty Mule MM371,
MM372, MM571 or MM572 Automatic Gate Openers
Programming the FM134 and FM135 Remote to Mighty Mule MM271 or
MM272 Automatic Gate Openers
2
1. Press and hold the
gate opener’s S3
button ( ) located
on the control board
until you hear a
beep.
S4
S3
S2
LED1
LED2
LED3
1
©2021 Nortek Security & Control LLC. All rights reserved. Mighty
Mule is a registered trademark of Nortek Security & Control LLC.
Mighty Mule Sales: 800-543-4283
Mighty Mule Technical Support: 800-543-1236
(Mon-Fri 8am - 7pm EST • Saturday 10am - 6:30pm EST)
5919 Sea Otter Place, Carlsbad, CA, 92010
For more information on Mighty Mule’s full line of Automatic Gate Operators, Gate Openers
and Access Controls visit
www.mightymule.com
183-0140 Rev-F
4
Entry Transmitters
2. Press and hold the desired button on the remote (until
you hear a beep) to complete programming process. The
remote is now programmed to the gate opener.
ON/OFF Switch
NOTE: The process for programming any wireless accessory in the same process as erasing that accessory.
There is no indication that the accessory has been programmed or erased. Make sure to test the accessory
before programing, because you may unintentionally erase it.
4. Power off control box. Press and hold a transmitter button while
sliding the ON/OFF switch to the ON position. Continue to hold
the selected transmitter button for 8-10 seconds. You will hear
a single or a series of beeps, followed by a pause then a single
beep. Release transmitter’s button. Your personal code is now
programmed to that button.
1. Remove back cover of the opener remote.
2. Use small screwdriver
to move switches to
random positions. If you
have more than one
transmitter, set them all
with the same code.
1 2 3 4 5 6 7 8 9
3. Replace and secure back cover of the
opener remote.
NOTE: To program any
subsequent FM134 or
FM135 remotes after
the rst, simply adjust
the dip switch pattern
to match the already
programmed remote.
An innite number of
the transmitters may
be programmed in this
manner.
NOTE: To program any
subsequent FM134 or
FM135 remotes after
the rst, simply adjust
the dip switch pattern
to match the already
programmed remote.
An innite number of
the transmitters may
be programmed in this
manner.
1
3
4
2

Summary

Programming FM134;FM135 Remote to MM371;372;571;572 Gate Openers

Activate Gate Opener

Press and hold the gate opener's S3 button until a beep is heard.

Program Remote

Press and hold the desired remote button until a beep is heard to complete programming.

Programming Multiple Remotes

Adjust the dip switch pattern to match the first programmed remote for additional transmitters.

Programming FM134;FM135 Remote to MM271;272 Gate Openers

Prepare Remote and Opener

Remove the remote's back cover and power off the control box before programming.

Set Transmitter Dip Switches

Use a screwdriver to move switches to random positions for unique codes.

Activate ON;OFF Switch

Hold transmitter button while sliding the ON/OFF switch to ON for 8-10 seconds.

Mighty Mule FM134 Specifications

General

Brand	Mighty Mule
Model	FM134
Category	Transmitter
Language	English