4.
5.
6.
1.
2.
3.
Click Connect to establish a connection to your device through a wireless network.
Choose Quick setup and application will guide you through all basic configuration settings in a couple of easy steps.
An advanced menu is available to fully configure all necessary settings.
Powering
The device accepts powering from an Ethernet port (Passive PoE). Under maximum load, the power consumption of this device is 11 W.
Connecting to a PoE Adapter:
Connect the Ethernet cable from the device to the PoE+DATA port of the PoE adapter.
Connect an Ethernet cable from your local network (LAN) to the PoE adapter.
Connect the power cord to the adapter, and then plug the power cord into a power outlet.
Configuration
RouterOS includes many configuration options in addition to what is described in this document. We suggest starting here to get yourself accustomed to
the possibilities: .https://mt.lv/help
In case IP connection is not available, the Winbox tool ( ) can be used to connect to the MAC address of the device from the LAN side https://mt.lv/winbox
(all access is blocked from the internet port by default).
Mounting
The device is to be mounted vertically so that the Ethernet cable points downwards.
If you wish to tighten the device to a pole, you can do it with the provided mounting loops. The device comes bundled with two mounting loops – guide the
loops around the device through the provided edge markings, and around the pole where it will be mounted.
An electric tape can be used to increase friction between materials use it between clamps and the mounting surface. It will help to hold the device in place.
The mounting hose clamp is provided with the package.
Mounting and configuration of this device should be done by a qualified person.
To Next Page
Loading...
