Need help?Do you have a question about the Milennia MIL-AMP200BT and is the answer not in the manual?
General guidelines for safely installing the amplifier, emphasizing care around vehicle components and fuse replacement.
Step-by-step instructions for connecting ground, remote, power, and input/output cables to the amplifier.
Addresses common amplifier problems like no power, protection LED, no output, hiss, and overheating with possible remedies.
Provides safety precautions and instructions for connecting the +12 Volt power, ground, and remote turn-on wires.
Recommends RCA input wiring for best audio performance, advising against connecting both high and low level inputs simultaneously.
Instructions for using high-level inputs when RCA outputs are unavailable, connecting speaker outputs from the receiver.
General| Bluetooth Connectivity | Yes |
|---|---|
| Minimum Speaker Impedance | 2 Ohms |
| Frequency Response | 20Hz - 20kHz |
| THD at Rated Power | <0.05% |
| S/N Ratio | >90dB |
| Input Sensitivity | 200mV - 6V |
| Bluetooth Version | 5.0 |
| Signal-to-Noise Ratio | >90dB |
| Output Connectors | Screw Terminals |
| Inputs | RCA |
| Input Voltage | 12V DC |
To Next Page