Miles Industries 700I User Manual (English)

To Next Page

Ceramic Rocks Installation

For ceramic logs, see previous section. Unpack the ceramic rocks very carefully to avoid damaging them. Install

the rocks as shown.

Please note that the position of some of the rocks identiﬁ ed in the following instructions is critical to ensure

proper performance of the appliance.

Note: The rocks 17 and 18, as well as the twigs may be installed or omitted at the customer’s choice.

1. Install the platform into the ﬁ rebox on top of the

burner. The metal tabs at the bottom of the platform

slide into the slots in front of the burner.

3. Insert the ceramic rock base in the platform behind

the burner. Ensure that the base lies against the

metal tabs behind the burner.

4. Each rock is embossed underneath with a number

and an arrow indicating its position. The arrow

points to the front of the ﬁ replace when the rock

is installed. See the image at the beginning of this

section to help you identify and position the rocks.

Metal tab

2 3

QUALIFIED

INSTALLER

Model 700I

Need help?

Do you have a question about the Miles Industries 700I and is the answer not in the manual?

Miles Industries 700I Specifications

General

Install the platform into the firebox and insert the ceramic rock base behind the burner, ensuring proper alignment.

Identify rocks by embossed numbers and arrows indicating front placement for correct installation.

Install front rocks (1-5) with pegs into designated holes on the rock base.

Place rear rocks (15-16) and pegged rocks (6, 8, 10, 12, 13) onto the platform.

Position rocks (7, 9, 11, 14) on pegs of other rocks, ensuring front orientation.

Slightly rotate specific rocks forward and optionally install rocks 17 and 18.

Optionally lay twigs and add front bricks, ensuring they do not block flames or burner.

Install side shrouds and front trim to the appliance outer case as indicated, using screws.