MileSeey S3 - Error Code

11. Error Code
Code
Cause
Corrective Measure
156
Transverse tilt greater than
10°
Hold the instrument without any transverse tilt
160
Main tilt direction, angle too
high (> 45°)
Measure angle up to max. ± 45°
162
The calibration has not been
accomplished on a leveled
surface
Calibrate the device on an absolute Horizontal
leveled surface.
204
Calculation error
Refer to user menu, repeat the procedures
208
Temperature too high
Cool down
220
Battery too low
Recharge battery
252
Temperature too High
Cool down instrument
253
Temperature too Low
Warm up instrument
255
Receiver signal too weak,
measurement time too long
Use target plate or change a good refection
256
Received signal too strong
Target too reflective use target plate or do not aim
at strong light objective
Error
Hardware error and
uncertainty error
Switch on/off the device several times. If the
symbol still appears, then your instrument is
defective. Please call your dealer for assistance
Cosinus Messtechnik GmbH - Lise-Meitner-Straße 6 - 85521 Ottobrunn - www.cosinus.de - Tel: 089/66559410 - Fax: 089/66559430 - office@cosinus.de