18
(1) Confirm that the printer is connected to power supply and the paper roll
is loaded correctly.
(2) Confirm that the printer is turned off and the top cover is closed in place.
(3) Press and hold the FEED button, then press the POWER button to turn
on the printer; release the button after the printer is turned on.
The self-test method is as follows:
When the printer is initially installed or there are any problems with the printer,
you can run self-test program to confirm the following status firmware version,
printer parameter setting status, print quality, and related setting infor
mation of
external devices, etc. After confirming that there is no problem with the printer
after the self-test, please check other devices or software. This function runs
ndependently of other devices or software.
(1) To install Windows driver, please refer to "Driver Installation Instruction".
(2) Set the "port" of the Windows driver as the appropriate interface to use.
Print the test page with the "Print test page" function of Windows driver.
Printer UnpackingPrinter UnpackingPrint Self-Test PagePrint Self-Test Page
Printer UnpackingPrinter UnpackingPrint with the Window Driver
To Next Page
Loading...