MILL CUS1800MECWA - Page 7

Specifications
First use
Description of heater
transport. Contact the retailer or importer if you discover any visible damages to the
product.
Keep the outer packaging to transport the heater in the future. If you want to dispose
the packaging, make sure it is done properly. Keep plastic bags away from children.
After turning on the heater for the first time or after an extended period without use,
the heater can produce a burnt odor for a short time. This is normal.
Please read all the instructions carefully before use. Save the instruction manual for
future use.
With aluminium foot Without aluminium foot
Model Thermostat Color Amperage
Aluminium
foot
Power (W)
CUS1800MECWA WhiteMechanical
Mechanical
Mechanical
CUS1800MECW
CUS1800MECBA
White
1800
1800
Yes
N o
220-240V~, 50Hz
Black 1800Yes
220-240V~, 50Hz
220-240V~, 50Hz
A B
5
millnorway.com
EN
See figure 2 on separate illustration sheet
Parts for models with aluminium foot
• 8 screws (4 pre-mounted)
• 2 foot brackets
• 2 rails for the feet
Attention! The heater is equipped with a tip-over switch which turns the heater
off when tipped over. When moving and/or tilting the heater you would hear a
sound that may sound like a loose part inside — this is the tip-over switch and
it is completely normal.
Before first use
After unpacking the heater, check to make sure the product was not damaged during
See figure 1 on separate illustration sheet
1. Heat emission
2. Thermostat
3. Output selector
4. Legs (aluminium)
1. Heat emission
2. Thermostat
3. Output selector
5