Mille Rolfe SRGF21626L - User Manual

17 pages

Save Page as PDF

To Next Page

To Next Page

Loading...

42" /106.7cm Stone Tabletop Rattan Gas Firepit

Keep the instructions for future reference.

0063-20

Model No.: SRGF21626L

GB

Table of Contents

Questions and Answers

K
Krystal SmithAug 7, 2025
What to do if Mille Rolfe SRGF21626L Outdoor Fireplace has ignition failure?
- J
  Jessica HillAug 7, 2025
  If you're experiencing ignition failure with your Mille Rolfe Outdoor Fireplace, there are several potential causes: * The distance between electrode ignition pins may be too far. In this case, adjust the distance between the ignition pins to be 3-5mm. * The pulse line might be wrongly connected. Check that the electrode wire, switch wire on valve body, and pulse ignitor are properly connected. * The shield could be covered with media. Ensure the shield is not covered; remove any medium before ignition. * The battery might be low or dead. Verify the battery is installed and has sufficient power.
J
Jason CastanedaAug 14, 2025
Why is the burner flame incorrect on my Mille Rolfe SRGF21626L?
- L
  Lynn HoweAug 14, 2025
  If the burner flame on your Mille Rolfe Outdoor Fireplace is incorrect, it could be due to incorrect gas supply or pressure, or clogged or dirty burner ports. Check the gas supply pressure and clean the burner parts.
H
Hayden NelsonAug 22, 2025
How to fix delayed ignition on Mille Rolfe Outdoor Fireplace?
- J
  James MontesAug 22, 2025
  Delayed ignition in your Mille Rolfe Outdoor Fireplace can be caused by low gas pressure or clogged/dirty burner ports. You should check the gas supply pressure. Also, clean the burner parts referring to the "CLEANING AND MAINTENANCE" section of the manual for instructions.
M
Meagan DawsonAug 29, 2025
What to do if I smell gas odor from Mille Rolfe SRGF21626L Outdoor Fireplace?
- D
  dustin55Aug 29, 2025
  If you notice a gas odor coming from your Mille Rolfe Outdoor Fireplace, it may be due to a gas leak. You should check all gas connections to resolve this issue.

Summary

WARNINGS

General Safety and Operational Warnings

Essential safety guidelines for outdoor use, ventilation, gas cylinder handling, and operational precautions.

Technical Data

Gas Specifications and Country Compliance

Details on gas types, consumption, pressure, and country-specific category approvals.

Assembly Instructions Overview

Preparation and Required Resources

Guidance on preparing the assembly area, required personnel, time, and tools.

Further Information

Gas Cylinder Connection and Disconnection

Procedures for safely connecting and disconnecting LP gas cylinders, including important notes and danger warnings.

Leak Testing Procedure

Gas Leak Detection Steps

Step-by-step guide for performing leak tests on gas connections using a soap solution.

Minimum Clearance Requirements

Safety Distances from Combustible Surfaces

Specifies safe clearances from flammable surfaces and proper placement on level ground.

Lighting Procedure

Step-by-Step Ignition Guide

Instructions for safely lighting the gas fire pit, including flame characteristics.

Operating Procedure

Safe Operation and Shutdown

Guidelines for operation, noise, re-lighting, shutdown, and gas leakage events.

Cleaning and Maintenance

Regular Care and Cleaning Tips

Advice on cleaning exterior surfaces, burners, airflow, and checking hoses.

Storage Guidelines

Safe Storage Practices

Instructions for storing the fire pit and gas cylinder safely between uses and during off-season.

Troubleshooting Common Issues

Problem Identification and Solutions

Addresses gas odor, delayed ignition, and ignition failure with corrective measures.

Parts and Hardware Identification

Component and Fastener Lists

Detailed lists of all included parts and hardware with quantities and figures.

Assembly - Step 1 & 2

Attaching Legs to Table Top

Securing the leg with bracket and three legs to the table top assembly using bolts.

Assembly - Step 3

Connecting Support Structure

Attaching cylinder support tubes and horizontal support tubes using bolts and screws.

Assembly - Step 4

Installing Side Panels

Fastening the side panels to the legs using bolts.

Assembly - Step 5

Attaching Front Panel

Securing the front panel to the legs using bolts.

Assembly - Step 6

Attaching Door Panel and Handle

Connecting the door panel and handle using self-tapping screws.

Assembly - Step 7 & 8

Final Assembly and Battery Installation

Placing lava rocks, lid, and installing the AA battery into the control panel.

Mille Rolfe SRGF21626L Specifications

General

Brand	Mille Rolfe
Model	SRGF21626L
Category	Outdoor Fireplace
Language	English