R
Pellerin Milnor CorporationPellerin Milnor Corporation
P. O. Box 400, Kenner, LA 70063-0400
Litho in U.S.A.
BMP040094/2006482B
(Sheet 1 of 3)
Door Installation
MCR09E5, MCR18E4, MWR09E5, MWR18E4, MWR18X4
SECTION A-A
DETAIL A
ADHESIVE
10
GLASS 3
2
GASKET
11
SILICONE
(SEE
DETAIL A)
INSTALL THE GASKET INTO THE DOOR
BEFORE INSTALLING THE GLASS. THE
RUBBER SEAL JOINT SHOULD BE LOCATED
AT TOP DEAD CENTER OF THE DOOR.
ADJUST IF NECESSARY.
APPLY A FEW DROPS OF ADHESIVE (ITEM
10) OVER A 1” AREA, 4 PLACES, AT 90
DEGREES AROUND THE RUBBER SEAL, IN
THE AREA WHERE THE DOOR IS TO BE
SEATED.
APPLY A 1” BEAD OF SILICONE (ITEM 11) IN
4 PLACES, AT 90 DEGREES AROUND THE
RUBBER SEAL, IN THE AREA WHERE THE
GLASS IS TO BE SEATED.
WHILE INSTALLING THE GLASS INTO THE
RUBBER SEAL, ENSURE THAT NO SILICONE
IS EXPOSED ON OUTER SURFACE OF THE
RUBBER SEAL.
DOORGLASS
JOINT
GASKET
ADHESIVE
1” AREA
SILICONE
1” BEADS
A
A
1
2
3
9
SEE
BMP010016
DOOR GLASS INSTALLATION:
1.
2.
3.
4.
To Next Page