PELLERIN MILNOR CORPORATION
Display or Action Explanation
B2T2001016: Flushing water connection. This is the water that
goes into the supply compartment or pumped chemical manifold
to flush chemicals into the machine.
B2T2003001: Hold the side of the connection stationary with a
wrench as you tighten the connection with another wrench.
Otherwise, you may twist components, such as valves, damaging
them.
B2T2003002: CAUTION: Equipment and Textile Damage
Hazards—Chemicals leaked into the machine, particularly when
it is idle, can destroy machine components and textiles left in the
machine.
Ensure the chemical system prevents dribbling, siphoning, or any
other unintentional release of chemicals.
Inspect regularly for proper operation and evidence of damage.
Consult Milnor document BIWUUI03 “Avoiding Damage from
Allied Remote Chemical Delivery Systems”.
B2T2008007: Do not exceed 160° Fahrenheit (71° Celsius)
water temperature. Excessive temperature can damage the water
valves in this machine. Eliminate water hammer on the water
lines to this machine. Water hammer can rupture the water inlet
valves on this machine. Follow applicable codes when installing
water hammer arresters. Maintain incoming water pressure
between 10 and 75 psi (between 0.7 and 5.1 bar). Pressures
outside this range can damage the water valves in this machine.
— End of BIUUUI02 —
To Next Page
Loading...
