SHOULDER STRAP
BANDOULIÈRE
CORREA DE HOMBROS
Cat. No. / No de cat.
49-16-2722
Nut
Bolt
Pole clip
Bevel
Gate
Carabiner
Vanne
Vis
Clip d’élagueuse
Écrou
Biseau
Mousqueton
Compuerta
Perno
Broche
del tubo
Tuerca
Bisel
Mosquetón
SAFETY WARNINGS
• Read this instruction sheet, and all manuals and
labels on your power tool.
• Always wear eye, hearing, and head protection,
and protective clothing and footwear, according
to the operation being performed. Wear heavy,
long pants, long sleeves, boots, and gloves.
Contain long hair. Do not wear loose clothing or
jewelry. Do not wear short pants, sandals, or go
barefoot.
• When using an attachment with larger-capacity
battery packs, use the shoulder strap to reduce
user fatigue and help in maintaining control of
the tool during use.
• Always turn o the tool and remove the battery
pack before installing or changing accessories.
ASSEMBLY
Attaching the Shoulder Strap
(For use with Cat. No. 2825-20)
When operating this tool, use the shoulder strap to
reduce user fatigue and help in maintaining control
during use.
To install the strap:
1. Remove the battery pack.
2. Fit the pole clip around the power head pole
between the front handle and rear handle in a
location comfortable during use.
3. Insert the bolt through the pole clip and strap bevel.
Thread the nut onto the bolt and tighten securely.
4. Clip the strap carabiner to the bevel.
To wear the strap:
1. Put your right arm and head through the strap.
2. Adjust the strap clips to change the strap length
to t comfortably.
3. Slide the neck pad to the appropriate position.
To unclip the strap:
1. Hold the tool by the front handle with your left
hand.
2. Grip the carabiner with your right hand and unclip
by pushing in the gate and it sliding o the bevel.
To Next Page
Need help?
General
