19
MJC680-2 Rev AA April 2019
INSPECTOR’S REPORT
ITEM REMARKS (LIST DEFICIENCIES AND RECOMMENDED ACTION)
Inspector’s
Signature
Date
Inspected
Approved By
Date
Figure 10B - Recommended Inspector’s Report
NOTE: All bearings except hook and idler sheave bearings are prelubricated and sealed.
* This lubrication schedule is based on a hoist operating in normal environment conditions. Hoists operating in adverse atmospheres containing excessive heat, corrosive fumes or vapors,
abrasive dust, etc., should be lubricated more frequently.
Figure 11 — Recommended Lubrication Schedule
RECOMMENDED LUBRICATION SCHEDULE* MILWAUKEE TOOL ELECTRIC POWERED CHAIN HOIST
Page and
Reference No
Component Type of Lubricant
Type of Service and Frequency of Lubrication.
HEAVY NORMAL INFREQUENT
Pages 30 & 31 Ref. No. 9 Load Chain SAE 90 gear oil Daily Weekly Monthly
Pages 28 & 29 Gearing SAE 90 WT extreme pressure (EP) gear oil At periodic inspection (see Figure 10A
Pages 26 & 27
Ref. Nos. 9 & 7
Limit Switch Shaft
Multi-purpose oil or general purpose
spray
Monthly Yearly Yearly
Pages 30 & 31
Ref. No. 19 & 31
Load Hook Bearing SAE 30 gear oil or motor oil Weekly Monthly Yearly
Pages 30 & 3 Ref. No. 28
Idler Sheave Bearing
(Bushing) Assembly
Multi-purpose lithium base
bearing grease - NLGI #2
At periodic inspection (see Figure 10A)
SECTION VII — INSPECTION CONTINUED
To Next Page
Loading...