WIRING INSTRUCTIONS
TITLE
DATE
MILWAUKEE ELECTRIC TOOL CORP. 13135 WEST LISBON RD. BROOKFIELD, WIS.
CORDLESS IMPACT WRENCH
58-01-1835
BULLETIN
Nov. 2002
NOTE:
All lead lengths are before stripping.
All leads must be held to ± .125"
unless specified elsewhere.
Strip wire per ES 13-11.
Crimp terminals per ES 13-15.
Drwg. 2
Wire Wire Origin or
No. Color Part No. Gauge Length Terminals, Connectors and End Wire Preparation
1 Black Motor Assy. - - Component of the motor assembly.
2 Red Motor Assy. - - Component of the motor assembly.
3 Red Switch Assy. - - Component of the switch assembly.
4 Black Switch Assy. - - Component of the switch assembly.
TERMINAL DESCRIPTION
Qty.Code Part No.
BULK LEAD WIRE - BULLETIN 58-01-0003
WIRING SPECIFICATIONS
AS AN AID TO REASSEMBLY,
TAKE NOTE OF WIRE ROUTING
AND POSITION IN WIRE GUIDES
AND TRAPS WHILE
DISMANTLING TOOL.
CONNECT WIRES AS SHOWN AND PLACE THE
COMPONENTS INTO THE LEFT HANDLE HALVE.
CAREFULLY ROUTE THE WIRES TO BE SURE THAT
THERE IS NO PINCHING WHEN
REASSEMBLING THE
RIGHT HANDLE
HALVE.
SOLDER BOTH MOTOR
LEADS TO THE SWITCH
AS SHOWN. DO NOT
USE TERMINALS.
WARNING
SWITCH POLARITY SENSITIVE
If #3 and #4 are wired incorrectly
with connector block, switch will
be damaged and destroyed!
!
Need help?
General
