MX FUEL
TM
LI-ION BATTERY PACKS
New batteries must be charged before first use. The
tool is shipped in sleep mode.
IMPORTANT SAFETY INSTRUCTIONS
- SAVE THESE INSTRUCTIONS -
WARNING
READ AND UNDERSTAND ALL
INSTRUCTIONS. Failure to follow
all instructions listed below, may result in electric
shock, fire and/or serious personal injury.
1.
2.
3.
4.
SAVE THESE INSTRUCTIONS - These
instructions contain important safety and
operating instructions for the MILWAUKEE
®
Li-Ion charger and MILWAUKEE
®
Li-Ion
battery packs.
10.
Do not short circuit. A short circuited battery
pack may cause fire, personal injury, and
product damage. A battery pack will short
circuit if a metal object makes a connection
between the positive and negative contacts on
the battery pack. Do not place a battery pack
near anything that may cause a short circuit,
such as coins, keys, or nails in your pocket.
11.
Do not allow fluids to flow into battery pack.
Corrosive or conductive fluids, such as
seawater, certain industrial chemicals, and
bleach or bleach containing products, etc., can
cause a short circuit.
12.
Do not hold or carry battery pack by
accessory handle while installed in tool.
13.
14.
Store your battery pack and charger in a
cool, dry place. Do not store battery pack
where temperatures may exceed 50°C
(120°F), such as in direct sunlight, a vehicle, or
metal building during the summer.
Always ship Li-Ion batteries in accordance
with the current regulations governing the
chosen mode of transport (e.g. ground, air,
sea). When in doubt, contact MILWAUKEE
®
,
the carrier, or other trained Dangerous Goods
professional to determine applicable
regulations.
Before using the battery pack and charger,
read this operator’s manual, tool's
operator’s manual, and all labels on the
battery pack, charger, and tool.
Use MILWAUKEE
®
Li-Ion
battery packs only on
1
CAUTION
recommended MILWAUKEE
®
Li-Ion
products. Do not use counterfeit, aftermarket,
or "knockoff" batteries or chargers. Do not wire
a battery pack to a power supply plug or car
cigarette lighter.
Avoid dangerous environments. Do not
charge battery pack in rain, snow, damp, or wet
locations. Do not use battery pack or charger in
the presence of explosive atmospheres
(gaseous fumes, dust or flammable materials)
because sparks may be generated when
inserting or removing battery pack, possibly
causing fire.
5.
Charge in a well ventilated area. Do not
block charger vents. Keep them clear to allow
proper ventilation. Do not allow smoking or
open flames near a charging battery pack.
Vented gases may explode.
6.
Do not burn or incinerate battery packs.
Batteries may explode. Toxic fumes and
materials are created when batteries are
burned.
7.
Do not crush, drop, or damage battery
pack. Always securely contain battery
packs during transport. Do not use a battery
pack that has received a sharp blow, been
dropped, run over, or damaged in any way
(e.g., pierced with a nail, hit with a hammer,
stepped on, in a vehicle accident). Do not use
or charge batteries that appear damaged or
swollen, or are not functioning properly.
9.
Battery chemicals cause serious burns.
Never allow contact with skin, eyes, or mouth.
If a damaged battery pack leaks battery
chemicals, use rubber or neoprene gloves to
dispose of it. If skin is exposed to battery fluids,
wash with soap and water and rinse with
vinegar. If eyes are exposed to battery
chemicals, immediately flush with water for 20
8.
Do not disassemble. If it is damaged, take it
to a MILWAUKEE
®
service facility.
minutes and seek medical attention. Remove
and dispose of contaminated clothing.
WARNING
Do not charge non-rechargeable
batteries.
WARNING
T
injury
o reduce
, and product damage
the risk of fire, personal
due to
a short circuit, never immerse your tool, battery
pack or charger in fluid or allow a fluid to flow inside
them. Corrosive or conductive fluids, such as
seawater, certain industrial chemicals, and bleach
or bleach-containing products, etc., can cause a
short circuit.
ADDITIONAL BATTERY SAFETY RULES
To Next Page
Need help?
General
