Milwaukee PD 705 - English

11
TECHNICAL DATA
Percussion Drill
PD 705
Production code 4319 56 02...
4319 71 02...
4526 02 02...
... 000001-999999
Rated input 705 W
Output 355 W
No-load speed 0-3000 min
-1
Speed under load max. 0-1890 min
-1
Rate of percussion under load max. 0-48000 min
-1
Static jamming moment* 15 Nm
Drilling capacity in concrete 15 mm
Drilling capacity in brick and tile 16 mm
Drilling capacity in steel 13 mm
Drilling capacity in wood 30 mm
Drill chuck range 1,5-13 mm
Drive shank 1/2” x 20
Chuck neck diameter 43 mm
Weight according EPTA-Procedure 01/2014 1,9 kg
Noise information
Measured values determined according to EN 60745. Typically, the A-weighted noise levels of the tool are:
Sound pressure level (Uncertainty K=3dB(A))
Sound power level (Uncertainty K=3dB(A))
Wear ear protectors!
98,5 dB (A)
109,5 dB (A)
Vibration information
Vibration total values (triaxial vector sum) determined according to EN 60745
Drilling into metal:
Vibration emission value a
h,D
Uncertainty K=
3,6 m/s
2
1,5 m/s
2
Impact drilling into concrete
Vibration emission value a
h, ID
Uncertainty K=
10,6 m/s
2
1,5 m/s
2
* Measured according to Milwaukee norm N 877318
WARNING!
The vibration emission level given in this information sheet has been measured in accordance with a standardised test given in EN 60745 and
may be used to compare one tool with another. It may be used for a preliminary assessment of exposure.
The declared vibration emission level represents the main applications of the tool. However if the tool is used for dierent applications, with
dierent accessories or poorly maintained, the vibration emission may dier. This may signicantly increase the exposure level over the total
working period.
An estimation of the level of exposure to vibration should also take into account the times when the tool is switched o or when it is running
but not actually doing the job. This may signicantly reduce the exposure level over the total working period.
Identify additional safety measures to protect the operator from the eects of vibration such as: maintain the tool and the accessories, keep
the hands warm, organisation of work patterns.
WARNING Read all safety warnings and all instruc-
tions. Failure to follow the warnings and instructions may result
in electric shock, re and/or serious injury.
Save all warnings and instructions for future reference.
DRILL SAFETY WARNINGS
Wear ear protectors when impact drilling. Exposure to noise
can cause hearing loss.
Use auxiliary handle(s), if supplied with the tool. Loss of
control can cause personal injury.
Hold the power tool by insulated gripping surfaces, when
performing an operation where the cutting accessory may
contact hidden wiring or its own cord. Cutting accessory con-
tacting a “live” wire may make exposed metal parts of the power
tool “live” and could give the operator an electric shock.
Additional Safety and Working Instructions
Use protective equipment. Always wear safety glasses when
working with the machine. The use of protective clothing is re-
commended, such as dust mask, protective gloves, sturdy non-slip
footwear, helmet and ear defenders.
Keep mains lead clear from working range of the machine. Always
lead the cable away behind you.
Do not machine any materials that present a danger to health (e.g.
asbestos).
When working in walls ceiling, or oor, take care to avoid electric
cables and gas or waterpipes.
Clamp your workpiece with a clamping device. Unclamped
workpieces can cause severe injury and damage.
Do not use diamond core drills on hammer mode.
GB
English