Milwuakee M18 FUEL 2736-20 User Manual

Cat. No. / No de cat.
2736-20
M18™ FUEL™ 8 1/4" TABLE SAW W/ ONE-KEY™
SCIE A TABLE DE 210 mm (8 1/4") M18™ FUEL™
AVEC ONE-KEY™
SIERRA DE MESA DE 210 mm (8 1/4") M18™ FUEL™ CON
ONE-KEY™
OPERATOR'S MANUAL
MANUEL de L'UTILISATEUR
MANUAL del OPERADOR
WARNING To reduce the risk of injury, user must read and understand operator's manual.
AVERTISSEMENT An de réduire le risque de blessures, l'utilisateur doit lire et bien
comprendre le manuel.
ADVERTENCIA Para reducir el riesgo de lesiones, el usuario debe leer y entender el manual.

Milwuakee M18 FUEL 2736-20 Specifications

General

Model Number	2736-20
Power Source	Battery
Motor Type	Brushless
Voltage	18V
No Load Speed	5, 800 RPM
Electric Brake	Yes
Spindle Lock	Yes
Category	Saw
Arbor Size	5/8 in
Max Cut Depth at 45 Degrees	1-7/8 in
Bevel Capacity	50 degrees
Blade Diameter	7-1/4 Inch
Tool Length	14-1/2 inches

Summary

General Power Tool Safety Warnings

Work Area Safety

Keep work area clean and well lit. Cluttered or dark areas invite accidents.

Electrical Safety

Protect power tool plugs from outlets and avoid body contact with earthed surfaces.

Personal Safety

Stay alert, use common sense, and wear eye protection and other PPE.

Specific Safety Rules for Table Saws

Guarding Related Warnings

Keep guards in place and ensure proper mounting for safety.

Cutting Procedures Warnings

Kickback Causes and Related Warnings

Table Saw Operating Procedure Warnings

Assembly

Selecting, Installing, and Changing Blades

Changing the Throat Plate

Instructions for replacing the throat plate on the saw.

Changing the Riving Knife

Installing Anti-kickback Pawls

Changing Blade Depth

Installing and Moving the Rip Fence

Auxiliary Fence and Miter Gauge Usage

Using the Miter Gauge

Guide on using the miter gauge for accurate angled cuts.

Operation Guidelines

Causes of Kickback

Explains factors leading to kickback and how to avoid it.

Turning Saw ON/OFF

Cutting Rules and Types

Cutting Rules

General rules for safe and effective cutting operations.

Making Basic Cuts

Making a Cross Cut

Making a Rip Cut

Making a Miter Cut

Advanced Cut Procedures

Making a Bevel Cross Cut

Making a Compound (Bevel) Miter Cut

Making a Non-Through Cut

Making a Dado Cut

Troubleshooting

Maintenance and Adjustments

Adjusting the Throat Plate

Blade Angle (Bevel) Adjustment

Blade Alignment Procedures

Blade to Miter Slot Adjustment (Heeling)

Blade to Fence Adjustment

Riving Knife Alignment