Mimosa Backhaul and B24 Help Content
Mimosa Backhaul Dashboard
Copyright © 2018 Mimosa Page Page 22
SFP Speed - Shows data rate and duplex mode if the link is up else "Link Down". Shows "Off" if the interface is
●
not enabled.
Network Interface - Shows the interface enabled; "Ethernet" or "SFP".
●
Firmware - The latest firmware version applied to each device (Set in Preferences > Update & Reboot).
●
Internal Temp - Temperature inside the device casing (operating range: -40 °C to +60 °C).
●
11 GHz MAC - The unique identifier for the 10/11 GHz radio.
●
2.4 GHz MAC - The unique identifier for the 2.4 GHz radio.
●
Ethernet MAC - The unique identifier for the physical Ethernet interface.
●
SFP MAC - The unique identifier for the physical SFP interface.
●
Last Reboot - The date and time at which each device last rebooted.
●
B24
Device Name - The friendly name given to each device. (Set in Preferences > General > Naming)
●
Serial Number - The unique identifier for the device assigned at the factory.
●
IP Address - The IP address of each device and how it was assigned. (Set in Preferences > Management)
●
Wireless Protocol - The MAC level protocol. (Set in Wireless > Link > MAC Configuration)
●
TDMA Traffic Balance - Identifies the "gender" of the radio, the duration for each TDMA time slot, and ratio of
●
bandwidth allocated for transmission. (Set in Wireless > Link > MAC Configuration)
Ethernet (RJ45) Status - Shows data rate and duplex mode if the link is up else "Link Down". Shows "Off" if the
●
interface is not enabled.
Fiber (SFP) Status - Shows data rate and duplex mode if the link is up else "Link Down". Shows "Off" if the
●
interface is not enabled.
Network Interface - Shows the interface enabled; "Ethernet (RJ45)", "Fiber (SFP)" or "Failover Ethernet (RJ45)".
●
Firmware - The latest firmware version applied to each device (Set in Preferences > Update & Reboot).
●
Internal Temp - Temperature inside the device casing (operating range: -40 °C to +90 °C).
●
2.4 GHz MAC - The unique identifier for the 2.4 GHz radio.
●
24 GHz MAC - The unique identifier for the 24 GHz radio.
●
Ethernet MAC - The unique identifier for the physical Ethernet (RJ45) interface.
●
SFP MAC - The unique identifier for the physical Fiber (SFP) interface.
●
Last Reboot - The date and time at which each device last rebooted.
●
To Next Page
Loading...
Need help?
General