Mimosa Backhaul Help Content
Mimosa Backhaul B5/B5c
Copyright © 2014 Mimosa Page 217
Improved Rate Adaption algorithm to achieve stable and consistently higher modulation at comparable SNR.
●
Performance improvement during fading conditions.
●
Improved (lower) PER in TDMA-FD modes.
●
User Interface
Removed redundant reboot messages.
●
Fixed Channel Recommendations to exclude out of range power values.
●
Spectrum Analysis data displays correctly when using a 75/25 traffic split and 2ms TDMA windows.
●
Auto Everything power settings are synchronized between the Channel & Power page and Dashboard page.
●
Updated formatting on the station side’s Site Survey report to display results without requiring scrolling.
●
User Interface styling updates to improve usability.
●
Known Issues
Site Surveys can only be performed while the radio is in Station mode.
●
Both channels must be changed at the same time in Frequency Diversity (FD) mode for changes to take effect.
●
Firmware Version 1.1.1
March 25, 2015
New Features
Timer-based operation (non-GPS mode) for workbench testing prior to deployment
●
TDMA-FD 1x modes allow separate Tx frequencies per side
●
Mobile-optimized Aiming Mode screen updates signal strength once per second
●
Auto Everything recommendations on Channel & Power page
●
Dynamic GPS location and distance calculation updates for mobile links
●
Cloud link on Dashboard leads to historical data in Manage application
●
Reset Device Unlock button locks the device and resets the country code without rebooting
●
Reset Device Configuration button clears configuration settings and device remains unlocked
●
Performance Improvements
Auto Everything channel and power selection algorithm improvements
●
Improved noise immunity in presence of interference
●
Improved association time between AP and STA
●
Regulatory domain updates
●
General stability improvements
●
User Interface Changes
MAC throughput on signal meter shows expected performance based on TDMA settings
●
Removed antenna gain and exclusion list from STA (STA values are obtained from AP)
●
Additional antenna selection options on B5c
●
Password change required after device reset
●
Password validation to allow letters, numbers and symbols up to 64 characters
●
Loading screen limited to content pane
●