INSTRUCTIONS FOR THE CT15 SERIES
MICROPROCESSOR BASED
TEMPERATURE CONTROLLER
MODEL IDENTIFICATION
Alarm
0 = No
1 = Yes
Input
1 = Thermocouple, J, K, T
2 = 100
Ω Platinum RTD
(DIN), element PD
Model CT15
Output
1 = SSR
2 = 5 VDC
3 = Relay
LIMITED WARRANTY
Minco Products, Inc. warrants to the Buyer that any equipment sold will be free from
defects in material or workmanship. If, at any time within thirtysix (36) months after
shipment of CT15 Series Controls or within three (3) months after shipment of other
assemblies or parts, the Seller is notified of such defect and the defective item is returned
to Seller by Buyer, transportation prepaid, for examination, the Seller will, at his option,
either repair or replace the defective items.
This warranty shall be effective only if installation and maintenance is in accordance with
Seller's instructions and the defect is not caused by shipping damage, misuse or abuse
by the Buyer. There are no other warranties, written, oral, or implied. The liability of the
Seller is limited to the repair or replacement of the defective item as set forth above.
Items which wear or are perishable by misuse are not warranted. These include, but are
not limited to, relays, contact points, lamps, LEDs, load SCRs, SSRs, and triacs.
(All dimensions in mm with inches in parentheses.)
Panel cutout for all models 45 mm X 45 mm (1.775" X 1.775"). Allow for
13 mm (0.5") clearance at the rear of instrument.
*Present for SSR and 5 VDC output.
G:\MOD\CT15\LIT\759MN.PM5
7/03
360-00066
© 1994, MINCO PRODUCTS, INC. ALL RIGHTS RESERVED. NO PORTION MAY BE COPIED WITHOUT THE
EXPRESS WRITTEN CONSENT OF MINCO PRODUCTS, INC.
DIMENSIONS
To Next Page
Need help?
General
