25
For custom color adjustments the following “outer keys” are used:
· The upper left adjusts the Red values 0-7
· The lower left adjusts the Green values 0-7
· The lower right adjust the Blue values 0-7
· The upper right does not do anything.
When using the iLightz RGB 10 style lightframes, the following chart will assist you in select-
ing the correct color you wish to experience:
RGB 10 Lightframes SWITCHES “ON”
PURE RED Red
ULTRA RED RED
ROSE QUARTZ RED, Green, Blue
YELLOW Red, Green
CALIFORNIA GOLD RED, Green
“WHITE” Red, Green, Blue
PURE GREEN Green
AQUA Green, Blue
PURE BLUE Blue
INDIGO Blue, RED
VIOLET Blue, Red
Located on both the left and right sides of the RGB 10 lightframes are four color selection
switches, allowing for left / right independent color control. The right four switches control the
right eye color and the left four control the left eye. When a switch is to the left (next to the
numbers one through four) it is in the "OFF" mode. Likewise, when each switch is to the right
(the side with ON printed on the top right of the switch) it is in the "ON" mode. To select the
color you desire, simply refer to the color key above and set the color switch(es) accordingly.
For example, for PURE BLUE switch number one “ON” in both switches while all other
switches should be to the left or “OFF”. For INDIGO, switch one and three will be on, two and
four will be off.
For all other common power lightframes, whether using closed or open eye styles, simply plug
the lightframe jack into the left front ‘Light’ port.
Remember: You can preset the color brightness / intensity of the color stimulation by choosing
the desired level in the Personal Preference section of your iLightz.
To Next Page
Loading...