SET-UP
STEP 1
STEP 4 STEP 5
Construct the water dumper.
Inflate the mat –
be careful not to
over-inflate so
that the bottom
stays flat.
Snap together
the water wheel
pieces.
Make sure the spinners are
facing the correct direction
for maximum spin.
Connect
tall bases.
Look for arrows ( , ) throughout the instructions
to know which end is the closed end of the building piece.
Begin constructing the left side
of your Aqua Maze using the
whirlpool vortex, marble
catcher, a tall base,
curved track, 2 straight
tracks and 7 tubes.
Connect the left and right
sides of the build using a
spinner slide. Add a water
wheel, funnel, and 3 tubes.
Use a tall base,
curved track,
spinner slide,
and 21 tubes
to add on to
the remaining
arm of the
triple chute.
SET-UP
STEP 1
Put together specific pieces.
Connect 3 tubes under each arm
of the triple chute and 2 tubes and
a marble catcher in the middle.
Construct a double tower off one arm
of the triple chute using a curved
track, straight track, funnel,
and 15 tubes. Add on a
second arm of the
triple chute with the
water dumper
and 5 tubes.
STEP 3
STEP 3
STEP 4
STEP 5
Whirlpool
Vortex
Water
Wheel
Spinner
Slide
Spinner
Slide
Curved
Track
Construct the central base.
Triple
Chute
Marble Catcher
Curved
Track
Straight
Track
Funnel
Tall
Base
Marble
Catcher
Connect the left side and central base.
STEP 2
STEP 2
Construct the central base tower.
Funnel
Construct the right
base and tower.
Tall
Base
Water
Dumper
TIP
TIP
STEP-BY-STEP BUILDING GUIDE
STEP-BY-STEP BUILDING GUIDE
To Next Page
Need help?
General
