88
7−2−2. Change of set value
Warning ● When the set value for the comparator is set wrong, or set in the
wrong procedures, it may not obtain the correct results from the
comparator, and it may cause malfunctions in peripheral equipments
and also cause a damage as well.
Procedures
1
When the key is pressed in the measurement
mode, it shifts to the comparative value selection
mode, and the display of the load display section
changes to “SO”.
2
Select the number to be changed by key and
key.
To make effective for the SO set value, set
the F−33 as “00007：Comparator operation
(Normal operation)”.
When the change of set value is required to
interrupt, press the
key. It returns to
the measurement mode.
If you keep the instrument untouched for
approx. 20 seconds in the condition of change
of setting is available, the Measurement
mode can be re−entered automatically.
：Decrement key of load display section.
：Increment key of load display section.
：Set to “S0” of load display section.
To Next Page
