Minebea CSD-891B - Page 107

93
(1) When the both of S1 and S2 select “more than” with the Function F−32.
S1 judgement display, S1 open collector output ON at (S1 set value)≦(display value)
S2 judgement display, S2 open collector output ON at (S2 set value)≦(display value)
S0 judgement display, S0 open collector output ON at (S1 set value)＞(display value)
and also (S2 set value)＞(display value)
at the same time
S2 set value
Display (large)
Display (small)
S2 judgement display,
S2 open collector output
ON
OFF
S1 set value
S1 judgement display,
S1 open collector output
S0 judgement display,
S0 open collector output
ON
OFF
ON
OFF
(2) When the S1 selects “less than” and the S2 selects “more than” with the Function F−32.
S1 judgement display, S1 open collector output ON at (S1 set value)≧(display value)
S2 judgement display, S2 open collector output ON at (S2 set value)≦(display value)
S0 judgement display, S0 open collector output ON at (S1 set value)＜(display value)
＜(S2 set value)
ON
OFF
ON
OFF
ON
OFF
S2 set value
Display (large)
Display (small)
S2 judgement display,
S2 open collector output
S1 set value
S1 judgement display,
S1 open collector output
S0 judgement display,
S0 open collector output
 ● Above figure indicates the case of (S1 set value)<(S2 set value).
In the case of (S1 set value)≧(S2 set value), the S0 judgement display
and the S0 open collector output will be normally OFF.