Minebea CSD-891B - Page 108

94
(3) When the S1 selects “more than”, and the S2 selects “less than” at the function F−32.
S1 judgement display, S1 open collector output ON at (S1 set value)≦(display value)
S2 judgement display, S2 open collector output ON at (S2 set value)≧(display value)
S0 judgement display, S0 open collector output Normally OFF
ON
OFF
ON
OFF
ON
OFF
S2 set value
Display (large)
Display (small)
S2 judgement display,
S2 open collector output
S1 set value
S1 judgement display,
S1 open collector output
S0 judgement display,
S0 open collector output
 ● Above figure indicates the case of (S1 set value)＜(S2 set value).
In the case of (S1 set value)≧(S2 set value), the S0 judgement display
and the S0 open collector output will ON in the condition of (S2 set
value)＜(display value)＜(S1 set value)
(4) When both of the S1 and S2 select “less than” at the function F−32
S1 judgement display, S1 open collector output ON at (S1 set value)≧(display value)
S2 judgement display, S2 open collector output ON at (S2 set value)≧(display value)
S0 judgement display, S0 open collector output ON at (S1 set value)＜(display value)
and also (S2 set value)＜(display value)
at the same time.
ON
OFF
ON
OFF
ON
OFF
S2 set value
Display (large)
S2 judgement display,
S2 open collector output
S1 set value
S1 judgement display,
S1 open collector output
S0 judgement display,
S0 open collector output
Display (small)