INDEX
Forwards Ⅰ....................................................................
Marks and arrangements used in this manual Ⅱ....................................
For safe operation Ⅲ............................................................
1. Installation place Ⅲ.........................................................
2. Power supply Ⅴ............................................................
3. Application note Ⅴ.........................................................
History of revision Ⅶ............................................................
1. General 1.................................................................
1−1. Features 1............................................................
2. Name and function of each point 2..........................................
2−1. Front panel 2.........................................................
3. Installation procedures 4...................................................
3−1. Installation place 4....................................................
3−2. Location where installation is not allowed. 4.............................
3−3. Installation 5.........................................................
4. Connecting method 6......................................................
4−1. Layout of the terminal boards 6.........................................
4−2. Note on connection 7..................................................
4−3. Connection 8..........................................................
4−3−1. Connection with strain gage applied transducers 8..................
4−3−2. Connection with external control inputs 18..........................
4−3−3. Connection with open collector output 19...........................
4−3−4. Connection with the power supply and the earth 20...................
5. Calibration procedures 21...................................................
5−1. Preparations 21........................................................
5−2. Calibration procedures 21...............................................
5−2−1. Calibration method to register the output of strain gage applied transducer
at the time of maximum display after setting the load to zero. 22.......
5−2−2. Calibration procedures to register the output of strain gage applied
transducer at the time of zero and the maximum display 28............
5−2−3. Calibration method to register by reading output value
of strain gage applied transducer in the conditions
of zero/actual load application individually 34........................
5−2−4. Zero fine adjustment 41............................................
5−2−5. Span fine adjustment 44...........................................
5−2−6. Calibration procedure to apply registration again for zero point only 47
5−3. Calibration method by communication 51.................................
5−3−1. Calibration method by communication to register the output
of strain gage applied transducer at the time of maximum display
after setting the load to zero. 52....................................
5−3−2. Calibration procedures by communication to register the output of strain gage
applied transducer at the time of zero and the maximum display 57....
5−3−3. Calibration method by communication to register
by reading output value of strain gage applied transducer
in the conditions of zero/actual load application individu 62...........
5−3−4. Zero fine adjustment by communication 68..........................
5−3−5. Span fine adjustment by the communication 71......................
5−3−6. Calibration procedure by the commnunicaitonto apply registration
again for zero point only 74........................................
5−4. Selection of calibration methods on each condition 77
......................
To Next Page
Loading...
