Minebea CSD-891B - Page 12

5−4−1. In case of executing the calibration on the instrument newly. 77.......
5−4−2. When the calibration is executed again 81...........................
5−5. Setting the prohibition against calibration 81..............................
6. Operation procedure 82.....................................................
6−1.
 key 82............................................................
6−1−1. Operations in Measurement mode 82...............................
6−1−2. When operating in the other mode 82...............................
6−2.
 key 82............................................................
6−2−1. When operating in the measurement mode 82........................
6−2−2. Operation is made in the other mode 83.............................
6−3.
 key 83............................................................
6−3−1. Operation is made in the measurement mode 83......................
6−3−2. Operation in the other mode 83.....................................
6−4.
 key 84............................................................
6−4−1. Operation in the measurement mode 84.............................
6−4−2. Operation in the other mode 84.....................................
6−5.
 key 84............................................................
6−5−1. Operation in the measurement mode 84.............................
6−6.
 key 84............................................................
7. Function and operation 85...................................................
7−1. External control input signal and Open collector output signal 85...........
7−1−1. External control input signal 85....................................
7−1−2. Open collector output signal 86.....................................
7−1−3. Equivalent circuit 87..............................................
7−2. Comparator 87.........................................................
7−2−1. ON/OFF for the Comparator S0, S1, S2, S3 and S4. 87................
7−2−2. Change of set value 88.............................................
7−2−3. Operation on comparator S1, S2, S3 and S4 90.......................
7−2−4. Comparative target for comparator S1, S2, S3 and S4 91..............
7−2−5. Operation of comparator S0 92.....................................
7−2−6. Hysteresis on comparator 95.......................................
7−3. How to use the filter 97.................................................
7−3−1. Analog filter 97...................................................
7−3−2. Digital filter 97...................................................
7−4. Selection of A/D sampling rate 98........................................
7−5. Zero tracking 98........................................................
7−5−1. What is zero tracking? 98..........................................
7−5−2. Setting related with zero tracking 99................................
7−5−3. Cancellation for compensation by zero tracking 100...................
7−6. Stabilized filter 100......................................................
7−6−1. What is the Stabilized filter? 100.....................................
7−6−2. Setting related with the Stabilized filter. 101..........................
7−7. Detection of stability 102.................................................
7−7−1. Range to detect stability 102........................................
7−7−2. Time to detect stability 102.........................................
7−8. Various kinds of functions related with the display 103......................