Minebea CSD-891B - Page 13

7−8−1. Selection of display rate 103.........................................
7−8−2. Selection of decimal point display position 103........................
7−8−3. Load display range 103.............................................
7−9. Selection the target for HOLD 103.........................................
7−10. Change of bridge power supply voltage 104.................................
7−11. Tare weight cancellation (A/Z) 105........................................
7−12. Zero set 105.............................................................
7−13. Key lock function 105....................................................
7−14. CHECK value 106.......................................................
7−15. Record place of set data etc. 106...........................................
7−16. Prohibition of calibration 106.............................................
7−17. Check mode 107.........................................................
7−17−1. Operating procedure for the check mode 107..........................
7−18. Monitor mode 115.......................................................
8. Function mode 118..........................................................
8−1. Setting method for function mode 118.....................................
8−2. Function of Function data 121............................................
9. Options 130.................................................................
9−1. Analog output 130.......................................................
9−1−1. Relative function 131...............................................
9−1−2. Specification of current output 131..................................
9−1−3. Specification of voltage output 131...................................
9−1−4. Connection of the current output 132................................
9−1−5. Connection with the voltage output 133..............................
9−1−6. Scaling of analog output 134........................................
9−1−7. Fine adjustment 1 on analog output 135..............................
9−1−8. Fine adjustment 2 on analog output 138..............................
9−2. BCD output 141.........................................................
9−2−1. Related function 141...............................................
9−2−2. Specifications for BCD output 141...................................
9−2−3. Pin configurations for the BCD output connector 142..................
9−2−4. Equivalent circuit for input/output 143...............................
9−2−5. Timing chart 144..................................................
9−2−6. Output condition 145...............................................
9−2−7. Selection of output logic for P.C.(Print command), and of its width 146...
9−3. RS−232C interface 147..................................................
9−3−1. Related function 147...............................................
9−3−2. Specifications for interface 147
......................................
9−3−3. Procedures of data transfer 148......................................
9−3−4. Pin configurations for connector pin 149.............................
9−3−5. Data format 150...................................................
9−3−6. Communication error process 164...................................
9−4. RS−422/485 interface 165................................................
9−4−1. Related functions 165..............................................
9−4−2. Specifications on interface 166......................................
9−4−3. Procedure of data transmission 166..................................
9−4−4. Pin configurations for connector pin 167.............................
9−4−5. Data format 169...................................................
9−4−6. Communication error process 183...................................
10. Trouble shooting 184........................................................