Minebea CSD-891B - Page 126

112
Procedures
・Check on analog output
 When the analog output is not installed,
proceed to the step 9.
Press the
 key.
The display in the load display section becomes
“A −OUT”. Press the
 key again, then the
display shows “LOW” and flashing on and off.
At this time, the analog output makes the value
equal to the “LOW” value shown in the below
table.
Every time the
 key is pressed, the display
h
th
k
idi t
d
l
8
changes as th
e
arrow marks indicate, and also
the analog output changes as shown in the below
table.
「LOW」
↓↑
「MID」
↓↑
「HIGH」
Options
(Current output)
Option
(Voltage output)
MID
HIGH
LOW
5V
10 V
0V
12 mA
20 mA
4mA
 The output values here reflect the values
adjusted in the paragraph 9−1−7, and
9−1−8.
 key ：Change the analog output from
up to down in the left column.
 key ：Change the analog output from
down to up in the left column.
9
Press the  key.
The load display will show “BCD”.
By pressing the
 key again, the display will
show “00000” and the digit of 10
0
flashes on and
off.
At this moment, the same value as the display
will output from the BCD output. When changing
the display with the right keys, the BCD output
will change corresponding to it.
・Check on the BCD output
 In case that the BCD output isn’t installed,
shift to the step 10.
 key ：Set value carry key
 key ：Set value inclement key.