111
Procedures
・Check on the open collector output
Press the
key.
The display of the load display section
becomes “S−OUT”.
Press the
key again, the load display
section displays “S0” and flashes on and off.
At the same time, by the operations of right
keys, each open collector output, each
judgement display and load display section
changes as below:
「RUN」
↓↑
「ERROR」
7
「S0」
↓↑
「S1」
↓↑
「S2」
↓↑
「S3」
↓↑
「S4」
key ：Set ON the each open collector
output from the above to the below
in order on the right figure.
key ：Set ON the each open collector
contact output from the below to the
above in order on the right figure.
RUN display：RUN output
ERROR display：ERROR output
S0 display：S0 output
S1 display：S1 output
S2 display：S2 output
S3 display：S3 output
S4 display：S4 output
To Next Page
