139
Procedures
6
Press the key.
The load display shows the current load value
and flashes on and off.
At the same time, adjust the deviation of analog
output against the load with the right keys.
By pressing the key continuously,
increment can be provided continuously.
key ：Decrease the analog output
key ：Increase the analog output
Press the key.
The load display shows “END”.
By pressing the
key again, the
Measurement mode can be returned through the
VADJ mode, then the present load will be shown.
At this moment, the result of fine adjustment on
the minimum/maximum output of analog output
can be renewed.
To Next Page
