145
9−2−7. Selection of output logic for P.C.(Print command), and of its width
Selection of the P.C. logic for BCD output, and its width can be made by setting
function. (Related function：F−44, F−45)
Select the P.C. width to meet with the output rate set by F−46, and execute the suitable
selection according to the following list.
Out
ut
P.C. width
rate(F−46)
Approx.125 ms Approx.25 ms Approx.10 ms Approx.5 ms Approx.2.5 ms
4 times/s ○ ○ ○ ○ ○
20 times/s × ○ ○ ○ ○
50 times/s × × ○ ○ ○
100 times/s × × × ○ ○
200 times/s × × × × ○
○：Possible to use, ×：Impossible to use.(P.C. output doesn’t operate correctly.)
Warning ● The selection of P.C. width should be made adequately according to
the output times set with the F−46. If neglected, the P.C. output will
not operate correctly.
To Next Page
