Minebea CSD-891B - Page 169

155
8
Reading out the function data(Host→CSD−891B)
2 4 6 8 10 12 14
@ 0 0 7 1 0 1 Terminator
Function No.
Command No. Space
Function No.
Operation
01 Reading out the setting value for the display position of decimal point
(Contents of F−01)
02 Reading out the setting value of A/D damping rate(Contents of F−02)
03 Reading out the setting value of display rate (Contents of F−03)
04 Reading out the setting value of digital filter (Contents of F−04)
05 Reading out the setting value of analog filter (Contents of F−05)
06 Reading out the setting value of key lock (Contents of F−06)
08 Reading out the setting value of data width for zero tracking (Contents of F−08)
09 Reading out the setting value of time width for zero tracking (Contents of F−09)
10 Reading out the setting value of HOLD target (Contents of F−10)
11 Reading out the setting value of CHECK value (Contents of F−11)
12 Reading out the setting value of Bridge power supply voltage (Contents of F−12)
15 Reading out the setting value of digital filter for stabilized filter
(Contents of F−15)
16 Reading out the setting value of time width for stabilized filter (Contents of F−16)
17 Reading out the setting value of data width for stabilized filter (Contents of F−17)
20 Reading out the setting value of analog output target (Contents of F−20)
21 Reading out the setting value of the display value at the minimum value of analog
output (Contents of F−21)
22 Reading out the setting value of the display value at the maximum value of analog
output (Contents of F−22)
30 Reading out the setting value of comparator operation (Contents of F−30)
31 Reading out the setting value of comparator target (Contents of F−31)
32 Reading out the setting value of comparator direction (Contents of F−32)
33 Reading out the setting value of the application status for comparator S0
(Contents of F−33
34 Reading out the setting value of the application status for comparator hysteresis
(Contents of F−34)
35 Reading out the setting value of the application status for comparator hysteresis
(Contents of F−35)
36 Reading out the setting value of the time width of comparator hysteresis
(Contents of F−36)
40 Reading out the setting value of the BCD output target (Contents of F−40)
41 Reading out the setting value of the BCD output logic (Contents of F−41)
42 Reading out the setting value of the BCD polarity output logic (Contents of F−42)
43 Reading out the setting value of the BCD flag output logic (Contents of F−43)