42
Procedures
2
Press the key four times.
It makes the load display proceeded as
“FUNC”→“CCAL”→“ACAL” →“LCAL”
→“ZERO”.
Here, set the initial load application.
3
Press the key.
Zero fine adjustment mode can be entered, then
the display on load display shows the present load
value and lights on and off. At the same time, set
the present load value to “0” with the right keys.
By pressing the key continuously,
increment can be provided continuously.
The variation of load value for one push of
the right key is less than 1 digit of display.
Therefore, a few pushes of these keys are
required to get the change of 1 digit of
display value.
key ：Zero fine adjustment
display decreasing key
key ：Zero fine adjustment
display increasing key
4
Press the key.
The indication of load display shows “END”.
To Next Page
