84
6−4. key
6−4−1. Operation in the measurement mode
At the same time when the Tare weight cancellation (A/Z) works and the load display value
becomes the net weight display value, the “A/Z” on the status display lights up and load display
becomes “0”.
6−4−2. Operation in the other mode
(1) Calibration
The setting value is initialized in the each procedures of the calibration methods.
(2) Function mode
The function number and the setting value of the function is made compulsively to “0” in the
function mode.
(3) Setting of comparator
The set value is compulsorily made “0” with the set value of the comparator can set.
6−5. key
6−5−1. Operation in the measurement mode
At the same time when the function of the tare weight cancellation clear(A/Z OFF) works, and
the load display value becomes to the display value of the gross weight, “A/Z” in the condition
display section lights off.
6−6. key
When key is pressed, the changed set value is registered internally, and it comes off the
condition which can be set.
To Next Page
