83
6−2−2. Operation is made in the other mode
(1) Carrying−over of set value
Pressing the
key in the condition of displaying the various kinds of set value, the digit of
the setting value flashing on and off is going up from 10
0
to 10
1
,10
2
,10
3
and 10
4
one by one.
(However, the range of carrying−over is different according to number of digits of set value
and the presence of sign.)
(2) Changeover of the function, etc.
The changeover of the various kinds of function in the function mode and the check mode can
be made.
(3) Decrement in the fine adjustment
When the
key is pressed at the time of making fine adjustment on ZERO, SPAN and
analog output, the decrement can be made in the target value.
● In the operation method of the paragraph 6−2−2(3), when the key is
pressed for more than about 1 second, each operation will be executed
continuously at a constant interval without ON/OFF operation of the
key.
6−3. key
6−3−1. Operation is made in the measurement mode
When the display value on load display section is within 10 % against the maximum display
value, (Refer to the Chapter 5.), the “0” display will be shown compulsively due to the zero set
function of this operation . As for details, refer to the paragraph 7−12.
6−3−2. Operation in the other mode
(1) Increment of the set value
By pressing the
key with the condition of displaying various kinds of set values, the set
value will increase per one count from 0, 1, 2, 3, 4, 5, 6, 7, 8, 9 and 0 again in order.
(2) Increment in the fine adjustment
When the
key is pressed at the time of making fine adjustment on ZERO, SPAN and
analog output, the increment can be made in the target value.
● In the operation method of the paragraph 6−3−2(2), when the key is
pressed for more than about 1 second, each operation will be executed
continuously at a constant interval without ON/OFF operation of the
key.
To Next Page
Loading...
