EasyManua.ls Logo

Mini CONVERTIBLE - Page 105

Mini CONVERTIBLE
324 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Steptronic transmission: change from
selector lever position D to R, N or M/S.
Steptronic transmission: change from
selector lever position P to R, N, D or
M/S.
The vehicle begins rolling.
Window condensation when the auto-
matic climate control is switched on.
The vehicle battery charge is very low.
Excessive cooling of the car's interior
when the heating is switched on.
Manual transmission: low brake vacuum
pressure; this can occur, for instance if
the brake pedal is depressed a number
of times in succession.
Additional Auto Start/Stop
function
Depending on the vehicle equipment and
country-specific version, the vehicle fea-
tures a variety of sensors for assessing the
traffic situation. The Auto Start/Stop func-
tion uses this information to adapt to vari-
ous traffic situations in a proactive manner.
For instance, this applies to the following
situations:
When a situation is detected in which
the stopping time is expected to be very
short, the engine is not switched off au-
tomatically. A message appears on the
Control Display, depending on the situa-
tion.
When a situation is detected in which
the vehicle needs to drive off immedi-
ately, the engine is started automati-
cally.
The function may be restricted if the navi-
gation data is invalid, outdated or not avail-
able, for example.
Switching the system on/off
Using the button
Press the button.
LED comes on: Auto Start/Stop function
is deactivated.
The engine is started during an auto-
matic engine stop.
The engine can only be stopped or
started via the Start/Stop button.
LED goes out: Auto Start/Stop function
is activated.
Switching off the vehicle during an
automatic engine stop
During an automatic engine stop, the vehi-
cle can be switched off permanently, for in-
stance when leaving it.
Steptronic transmission:
1. Engage selector lever position P.
2. Press the Start/Stop button. The ignition
is switched off. The Auto Start/Stop
function is deactivated.
3. Set the parking brake.
Manual transmission:
1. Press the Start/Stop button. The ignition
is switched off. The Auto Start/Stop
function is deactivated.
2. Shift into first gear or reverse.
3. Set the parking brake.
Seite 105
Driving CONTROLS
105
Online Edition for Part no. 01405A53AA0 - II/22

Related product manuals