1. Press and hold the button to release the
selector lever lock.
2. With the driver's seat belt fastened,
briefly push the selector lever in the de-
sired direction, past a resistance point,
if needed. The selector lever automati-
cally returns to the center position when
released.
Engaging selector lever position P
Press button P.
Rolling or pushing the vehicle
General information
In some situations, the vehicle is to roll
without its own power for a short distance,
for instance in a car wash, or be pushed.
Engaging selector lever position N
NOTICE
Selector lever position P is automatically
engaged when the ignition is switched off.
There is a risk of damage to property,
among other potential damage. Do not
switch ignition off in car washes.
1. Start the engine while pressing on the
brake pedal.
2. If necessary, release the parking brake.
3. Depress the brake pedal.
4. Touch the selector lever lock and en-
gage selector lever position N.
5. Switch the engine off.
In this way, the ignition remains
switched on, and a Check Control mes-
sage is displayed.
The vehicle can roll.
Irrespective of the ignition, the selector
lever position P is automatically engaged
after approx. 15 minutes.
If there is a malfunction, you may not be
able to change the selector lever position.
Electronically unlock the transmission lock,
if needed, refer to page 123.
Kickdown
Kickdown is used to achieve maximum driv-
ing performance. Press down accelerator
pedal beyond the resistance point.
Seite 120
CONTROLS Driving
120
Online Edition for Part no. 01405A53AA0 - II/22
To Next Page
Loading...
