Cargo position
Concept
The rear seat backrests can be moved into
an upright loading position individually. An
adjustment in several tilt stages is possible
as needed.
Adjusting
1. Pull the strap.
2. Set the loading position of the rear seat
backrest as required.
3. Engage the rear seat backrest.
Folding back the backrest
1. Pull the strap.
2. Return the rear seat backrest to the up-
right seating position and engage it.
Variable cargo area floor
Concept
With the variable cargo area floor, the cargo
area can be configured corresponding to
transport requirements.
General information
Follow instructions on securing cargo, refer
to page 233.
Removing the cargo floor panel
1. Fold the rear part of the cargo floor
panel upward.
2. Grasp the cargo floor panel at the rear
and fold it upward.
3. Pull the cargo floor panel backward from
the brackets.
Inserting the cargo floor panel
1. Push the cargo area floor into the sup-
ports at a shallow angle. The cargo area
floor must engage noticeably.
Seite 237
Cargo area CONTROLS
237
Online Edition for Part no. 01402628632 - VI/19
To Next Page
Loading...
