MINICRAFT Bonanza F-33 User Manual

Bonanza F-33
The Beechcraft Bonanza was developed just after the end of WWII and first flown in 1947. Designed as a
low wing high performance private aircraft, the “V” tailed Bonanza combined performance and sleek looks
to deliver a very effective private airplane. However after years of utilizing the famous “V” tail design there
were numerous crashes mostly attributed to pilot error but the “V” tail design was recognized as a factor. In
the hands of inexperienced pilots the “V” tail could be difficult to master. The decision was made in the late
1950’s to modify the Bonanza V-35 to use a redesigned conventional tail, rudder and elevator structure that
significantly change the looks of the Bonanza. This kit represents the “re-designed” Bonanza F-33 from
1966.
This new 1/48 scale kit features new tail tooling, and new markings with decals printed by Cartograf.
Standard features include detailed 6 cylinder air cooled engine, removable cowling, detailed interior and
position-able landing gear.
The following markings are included in this kit:
Beech F33A Bonanza, N5599P, Airline Training Center, Arizona, 1998
Beech F33A Bonanza, N5585Y, Airline Training Center, Arizona, 1998
Minicraft Models (US) LLC, 1501 Commerce Drive, Elgin IL 60123 USA
www.minicraftmodels.com
Printed in China
11670

MINICRAFT Bonanza F-33 Specifications

General

Model	Bonanza F-33
Engine	Continental IO-520-BB
Horsepower	285 hp
Wingspan	33 ft 6 in (10.21 m)
Max Takeoff Weight	3, 400 lb (1, 542 kg)
Cruise Speed	176 knots (203 mph, 326 km/h)
Rate of Climb	6.2 m/s
Seating	6
Category	Aircraft

Summary

Bonanza F-33 Model Kit Introduction

Key Kit Features

Highlights new tooling, decals, engine detail, removable cowl, and landing gear.

Included Aircraft Markings

Specifies the two decal options for aircraft N5599P and N5585Y.

Parts Layout Diagram

Assembly Steps 1-4

Cockpit Assembly

Instructions for assembling the aircraft's interior cockpit and seats.

Instrument Panel Installation

Details on assembling and fitting the instrument panel and control yoke.

Cockpit and Wing Integration

Guidance for connecting the cockpit assembly with the upper and lower wings.

Fuselage Assembly

Steps for constructing the aircraft's fuselage halves and connecting them.

Assembly Steps 5-7

Tail Assembly

Instructions for constructing and attaching the aircraft's tail section components.

Engine Assembly

Steps for building the detailed 6-cylinder air-cooled engine.

Engine Installation

Guidance on fitting the assembled engine into the aircraft fuselage.

Final Assembly Step 8

Model Final Assembly

Completing the model with landing gear, propeller, and final exterior parts.

Landing Gear Door Placement

Instructions for attaching landing gear doors in a closed position.

Propeller Options Note

Information regarding the optional three-blade propeller.

Decal Scheme: N5599P

Paints for N5599P Scheme

Lists paint colors and corresponding ModelMaster numbers for the N5599P aircraft.

Decal Scheme: N5585Y

Paints for N5585Y Scheme

Lists paint colors and corresponding ModelMaster numbers for the N5585Y aircraft.

Decal Application Instructions

Decal Preparation and Cutting

Guidelines for safely cutting decals from the sheet and preparing them for application.

Waterslide Decal Application

Step-by-step process for applying decals using water and a brush.

Decal Setting and Sealing

Recommendations for using setting solutions and protective clear coats for durability.