miniland Thermosense - Page 37

37
ELECTROMAGNETIC COMPATIBILITY (EMC)
∙ This device should not be used adjacent to or stacked with other
equipment and that if adjacent or stacked use is necessary,
this device should be observed to verify normal operation in the
conguration in which it will be used
∙ Use of accessories other than those specied or provided by the
manufacturer of this device could result in increased electromagnetic
emissions or decreased electromagnetic immunity of this equipment
and result in improper operation.
∙ Portable RF communications equipment (including peripherals
such as antenna cables and external antennas) should be used no
closer than 30 cm (12 inches) to any part of the device, including
cables specied by the manufacturer. Otherwise, degradation of the
performance of this equipment could result.
∙ When the operating environment is relatively dry, strong
electromagnetic interference usually occurs. At this time, the device
may be affected as follows:
∙ - the device stops output;
∙ - the device turns off;
∙ - the device restarts;
∙ The above phenomenon does not affect the basic safety and
essential performance of the device, and the user can use it
according to the instruction. If you want to avoid the above
phenomenon, please use it according to the environment specied
in the manual.
Declaration - electromagnetic emission
The device is intended for use in the electromagnetic environment
specied below. The customer or the user of device should assure that it
is used in such an environment.
ENGLISH