Operating your Minivator Simplicity 950
Your Minivator stairlift is fitted with a key
switch (Figure 2).
The stairlift cannot be operated unless
the key is inserted and turned to the on
position.
The keyswitch is pr
ovided to enable
you to lock the stairlift to pr
event it
being used by others (for example
children).
However, it can be left in the on position
if desir
ed.
If you remove your key for safety
reasons, please ensure you put it in a
safe place.
If the keyswitch is tur
ned of
f the lift will
continue to char
ge.
As well as a key switch your stairlift is fitted
with an on/off switch (Figur
e 3) on the
bottom, side panel of the lift.
Ensure that this is left in the ‘ON’
position. The fault diagnosis display
panel will be illuminated to indicate this.
If you intend to be away from home for a
long period, and decide to switch off the
mains supply, it is important that you also
switch off the lift from this on/off switch.
This will ensure that the lift batteries will
remain charged while you are away.
Key switch
Diagnostic display
On/off switch
3
Figure 2 Figure 3
The stairlift is fitted with a diagnostic display
(Figure 3) that displays a code to help
diagnose faults. Refer to Appendix 3 for an
explanation of the diagnostic codes. If you
should experience a pr
oblem with your lift
please examine the display and make a note
of any codes that are displayed. Please
infor
m the customer ser
vices operator of
these codes when r
epor
ting any faults.
Operating your Minivator Simplicity 950
Operating lever
Before using your stairlift, MOST
IMPORTANTLY please ensure the stairs are
clear of other people, pets or any objects
which may obstr
uct your stairlift. Then
next, ensure that the arms, footplate and
seat ar
e folded down for use to ensur
e
your safety. (Figure 4).
BEFORE OPERATING YOUR
STAIRLIFT ALWAYS FASTEN
YOUR LAP BELT.
Y
our Minivator stairlift is operated by
simply pressing and holding the operating
lever in the dir
ection you wish to travel
(Figure 5). The stairlift will automatically
stop when the switch is released or the
stairlift has reached the end of its travel.
PLEASE NOTE:
In the interest of safety, initial activation
of the stairlift is delayed by 1 second fr
om
pressing and holding the operating lever,
to avoid accidental operation. If the switch
is released while the lift is in motion, the
lift will stop and a delay of 1 second will
occur before the switch will re-start the lift.
When changing the direction of travel the
delay will be 3 seconds befor
e the lift
begins to move.
4
Figure 4 Figure 5
To Next Page
Loading...
