MINIWARE TS80P - Page 23

Problem 5:
OLED displays “Sen-Err”
Check 1: Is the soldering iron installed propely?
Check 2: If check 1 passes, then replace the soldering tip.
Problem 6:
The tip doesn't stick to the
solder
Check if:
1. Tip temperature is over 400°C.
2. The soldering side of the tip is not applied with solder properly.
3. Lack of flux during operation.
4. Rub the tip against dry or high sulfur sponge or fabric.
5. Tip touched organic material like plastic, silicone oil or other chemicals.
6. Using impure solder or solder that contains low proportion of tin.
Problem 7:
TS80P can be heated normally when
it is powered by a power bank, but
shuts down after maintaining a
constant temperature
Check 1: Set the “LowCur" menu option to "ON".