Riptide Ulterra Foot Pedal
1866080
INSTALLATION
1. Remove protective covers from both connector ends.
2. Align connector keys and plug foot pedal into Riptide Ulterra trolling motor. Be sure to tighten the connector retaining nut.
NOTE: DO NOT APPLY LUBRICANT OR ANY TYPE OF GREASE TO TROLLING MOTOR CONNECTORS.
FOOT PEDAL FUNCTIONS
The foot pedal has dual mode operation: Normal Mode and Ulterra Mode.
ULTERRA MODE
To activate Ulterra mode, press the “Mode” button,
above the speed dial on the foot pedal. The yellow
MODE light will illuminate. When in Ulterra mode, the
foot pedal controls Stow, Deploy, and Trim, as well as
Spot-Lock and Auto Pilot.
NORMAL MODE
When in normal mode, the foot pedal controls
Speed, Steering, Prop on/off, Spot-Lock, and
AutoPilot. When in Normal mode the yellow light
will NOT be illuminated.
Momentary On Momentary On
Mode Mode
STEER RIGHT TRIM UP
PROP
(Momentary On)
STOW/DEPLOY
TO STOW: tap once
TO DEPLOY: tap twice in succession
STEER LEFT TRIM DOWN
Constant On Constant On
AUTOPILOT
SPOT-LOCK
MODE
CONSTANT
AutoPilot
On/Off
AutoPilot
On/Off
Speed
Control
Speed
Control
Spot-Lock Spot-Lock
Heel/toe steering Heel/toe steering
ENVIRONMENTAL COMPLIANCE STATEMENT: It is the intention of JOME to be a responsible cor-
porate citizen, operating in compliance with known and applicable environmental regulations, and a good
neighbor in the communities where we make or sell our products.
WEEE DIRECTIVE: EU Directive 2002/96/EC “Waste of Electrical and Electronic Equipment Directive
(WEEE)” impacts most distributors, sellers, and manufacturers of consumer electronics in the European
Union. The WEEE Directive requires the producer of consumer electronics to take responsibility for the
management of waste from their products to achieve environmentally responsible disposal during the
product life cycle. WEEE compliance may not be required in your location for electrical & electronic equip-
ment (EEE), nor may it be required for EEE designed and intended as fixed or temporary installation in
transportation vehicles such as automobiles, aircraft, and boats. In some European Union member states,
these vehicles are considered outside of the scope of the Directive, and EEE for those applications can be
considered excluded from the WEEE Directive requirement.
This symbol (WEEE wheelie bin) on product indicates the product must not be disposed of with other
household refuse. It must be disposed of and collected for recycling and recovery of waste EEE. Johnson
Outdoors Inc. will mark all EEE products in accordance with the WEEE Directive. It is our goal to comply in
AUTOPILOT
SPOT-LOCK
MODE
CONSTANT
A Johnson Outdoors Company
Minn Kota Consumer & Technical Service
Johnson Outdoors Marine Electronics, Inc.
PO Box 8129
Mankato, MN 56001
121 Power Drive
Mankato, MN 56001
Phone (800) 227-6433
Fax (800) 527-4464
minnkotamotors.com
©2016 Johnson Outdoors Marine Electronics, Inc.
All rights reserved.
Part #2207110
Rev B 3/18
ECN 39002
the collection, treatment, recovery, and
environmentally sound disposal of those products; however, these requirement do vary within European
Union member states. For more information about where you should dispose of your waste equipment for
recycling and recovery and/or your European Union member state requirements, please contact your dealer
or distributor from which your product was purchased.
DISPOSAL: Minn Kota motors are not subject to the disposal regulations EAG-VO
(electric devices directive) that implements the WEEE directive. Nevertheless never
dispose of your Minn Kota motor in a garbage bin but at the proper place of collection
of your local town council. Never dispose of battery in a garbage bin. Comply with the
disposal directions of
the manufacturer or his representative and dispose of them at the proper place of
collection of your local town council.
To Next Page
Need help?
General
